MRV Communications AE09~212FCAKA, AE212FCAKA, AE092FCAKA, AE072FCAKA, AE142FCAKA Clock set

Models: AE092FCAKA AE122FCAKA AE09~212FCAKA AE212FCAKA AE142FCAKA AE182FCAKA AE242FCAKA AE072FCAKA

1 37
Download 37 pages 33.48 Kb
Page 9
Image 9

D

Clock set

When unit is started for the first time, clock should be adjusted as follows:

Press CLOCK button, "AM"or "PM" flashes.

Press or to set correct time. Each press will increase or decrease 1min. If the button is kept depressed, time will change quickly.

After time setting is confirmed, press SET, "AM "and "PM" stop flashing, while clock

starts working.

Battery loading

Batteries are fitted as follows:

 

*

*

*

 

*

Remove the battery compartment lid

 

Slightly press and disengage the battery compartment lid marked with ì

î and then hold

the remote controller by the upper section and then remove the battery compartment lid by pressing in the direction of the arrow as shown in the figure above.

Loading the battery

Ensure that batteries are correctly placed in the compartment as required for positive and negative terminals.

Replacing the battery compartment lid

The battery compartment lid is reinstalled in the reverse sequence.

Display review

Press the button to see if batteries are properly fitted. If no display appears, refit the batteries.

Caution:

If the remote controller does not operate as designed after fitting new batteries of the same type, press the Reset button (marked ) with a pointed article.

Note:

It is recommended that the batteries be removed from the compartment if the remote controller is not used for an extended period.

The remote controller is programmed for automatic test of operation mode after the batteries are replaced. When the test is conducted, all icons will appear on the screen and then disappear if the batteries are properly fitted.

When the display become weak, this display no power in the battery, please change the battery.

 

5

2

4

 

3

 

1

R

1 .Emergency switch

2 .Power lamp

After open the unit, this lamp bright when the unite enter health running, the lamp change from orange to blue lamp.

3 .Timing lamp

When the unit been setting Timing running, this lamp bright.

4 .Running lamp

When the compressor working, this lamp bright. 5 .Indoor temp. sensor

Test the room temperature.

8

Page 9
Image 9
MRV Communications AE09~212FCAKA, AE212FCAKA, AE092FCAKA, AE072FCAKA, AE142FCAKA, AE182FCAKA, AE122FCAKA, AE242FCAKA Clock set