Miscellaneous | Multi-Tech Systems 410, MVP103 specs

Chapter 4 – Miscellaneous

In the Dial String box, enter the AT command for dialing (atdt) plus the phone number of the remote MultiVOIP.

Click OK when you are satisfied with your selections.

7.Run the MultiVOIP Configuration program. Click StartPrograms MultiVOIP 9.06.XX Configuration.

8.The Dialing dialog box displays while software is dialing the remote MultiVOIP.

9.The Reading Setup dialog box displays.

10.The MultiVOIP main menu displays. This is the main menu of the remote MultiVOIP.

11.Change the configuration of the remote MultiVOIP and then click Save and Reboot to update the configuration. The remote MultiVOIP will be brought down, the new configuration written to the unit, and the unit will reboot.

12.Close the configuration program when the downloading is complete.

13.If the same telephone number is not going to be used again in the immediate future, you may want to remove it from the Port Setup dialog box.

68	Multi-Tech Systems, Inc. Avaya Communication Manager Guide

Image 68

Multi-Tech Systems 410, MVP103 manual Miscellaneous

Contents

MultiVOIP Configuration Guide Revision Date Description Contents Introduction Introduction MultiVOIP in Avaya Communication Manager System Configuration Configuration Channel RTP Port Rtcp Port T38 Port Configuration Configuration Bandwidth per Channel Voice Frames per IP Packet Communication Manager MultiVOIP FXS Channels Configuration Configuration Communication Manager MultiVOIP FXO Channels Configuration = Isdn Communication Manager MultiVOIP did Channels Configuration = Isdn Configuration Configuration Configuration Configuration Configuration Configuration Configuration Configuration Configuration Configuration Regional Parameters screen Regional Parameter Definitions Field Name Values Description Regional Parameter Definitions Field Name Values Description Tone Pair Values Communication Manager Settings Related MultiVOIP Setup Parameters Related MultiVOIP Setup Parameters Version 4 Parameters Voice/Fax Parameters Channel to be configured is selected here Fax Enable Fax VolumeJitter Value Default = Mode Fax FRF 11 T.38 Advanced Features Jitter Auto Disconnect Automatic Interface Parameters Related MultiVOIP Setup Parameters FXS Not applicable to FXS interface FXO Interface Parameter Definitions Dialing Options FXO Disconnect On cont’d CID Number Voip Caller ID Case #4 Remote FXS call on H.323 voip system Did Options GK General Settings GK General Settings DefinitionsActivity Configuration Policy GK General Settings Definitions cont’d RAS Parameters Gatekeeper Endpoints Command Buttons Gatekeeper Calls Current Calls Field DefinitionsNumber. a sequential number for identification in the list ID alias of the endpoint originating the call Call Details Field Definitions Conference ID number CID is a unique non-zero value createdConference will have the same CID ID identifies the call with which the message is associated Total amount of bandwidth used by the call Type of conference request create, invite or joinLast reported state of the call Reason associated with the last state of the call H.323 alias name used to make the call E164 alias phone number used to make the callAn e-mail address used to make the call Address and port number Gatekeeper Network Parameters Network Parameter DefinitionsField Name Values Description Status Information Options ARQ Line Hunting Information Call Mode GK-ID Gatekeeper Services Services Screen DefinitionsField Name Values Description GK Defined Services Public Dynamic Miscellaneous Miscellaneous Comm Mgr Dialing Example #1 a local station-to-station call Remote Configuration Miscellaneous MVP130-AV Rev MVP130-AV Rev aMVP130-AV-FXS Rev a MVP210-AV Rev a Miscellaneous Link Management Feature Issues Index Index Coder field FRF11 Gatekeeper Response to field GK General Settings, RAS DID-DPO FXO Trunk Group form fields to set Dtmf Gain Unregister endpoints command Dtmf Gain High Tones