Multi-Tech Systems BL-Series manual BS n, $BA n, CD n, SN d, DF n, DP n, $D n

MultiModemBL User Guide

Command	Values	Description
***Bn	n = 0 or 1	* B0 selects V.21 answer tone.
		B1 selects Bell answer tone.
&Bn	n = 0 or 1	* &B0 means normal transmit buffer size.
		&B1 means reduced transmit buffer size.
&BSn	n = 0 or 1	&BS0 means maximum transmit block size of 64
		characters.
		* &BS1 means maximum transmit block size of 256
		characters.
$BAn	n = 0 or 1	* $BA0 means speed conversion is on.
		$BA1 means speed conversion is off.
&Cn	n = 0,1,2,4	&C0 forces Carrier Detect on.
		* &C1 lets Carrier Detect act normally.
		&C2 lets Carrier Detect drop S24 time on
		disconnect.
		&C4 resets modem when Carrier Detect drops.
&CDn	n = 0 or 1	* &CD0 execute cleardown on disconnect.
		&CD1 do not execute cleardown on disconnect.
Ds	s = phone #	Dial a telephone number “s,” where s may include
		up to 60 digits or T, P, R, comma and ; characters.
DsNd	s = phone #	Store telephone number. To store, phone d = 0 thru
		9 number ”s“ is entered and followed by N and then
		Directory Number “d.”
&Dn	n = 0 thru 3	** &D0 DTR is ignored
		&D1 means modem returns to command mode.
		* &D2 lets modem react to DTR normally.
		&D3 causes modem to reset to modem default
		parameters.
%DFn	n = 0 or 1	* %DF0 Line Probe Data in Graph Format.
		%DF1 Line Probe Data in Table Format.
%DPn	n = 0 or 1	* %DP0 do not read Line Probe Information from DSP
		during handshaking.
		%DP1 read Line Probe Information from DSP during
		handshaking.
$Dn	n = 0 or 1	* $D0 disables DTR Dialing.
		$D1 enables DTR Dialing.
En	n = 0 or 1	E0 means do not echo Command Mode Character.
		* E1 means do echo Command Mode characters.

*Factory Default Setting

**Factory Default Setting for BL-Mac

***Not applicable in BLK models

132