MT3334HD8 User Guide
78 CommPlete Communications ServerCommand Values Description
%Enn = 0–5 Escape Sequence Options
%E0 Modem won’t escape.
*** %E1 +++ method
%E2 Break method.
%E3 Either +++ or break methods.
*** % E4 No OK response to +++.
%E5 OK response to +++.
&Fnn = 0, 8, or 9 Load Default Configuration
&F0 Load factory default values from ROM.
*** &F8 Read factory default values and DIP switch
settings when &F is issued.
&F9 Read parameters stored in nonvolatile memory
when &F is issued.
$Fnn = 0 or 1 Auto-Reliable Fallback Character Enable
*** $F0 Do not fall back to non-error correction mode
connect if CR received.
$F1 Fall back to non-error correction mode connect
if CR received.
%Fnn = 0 or 1 Echo Canceler Offset Frequency Compensation
*** %F0 Disable echo canceler offset frequency
compensation.
%F1 Enable echo canceler offset frequency
compensation.
#Fnn = 0, 1, or 2 Fallback Modes When Online
#F0 No fallback when online.
#F1 Fall back incrementally from maximum speed to
4800 bps.
*** #F2 Fall back incrementally to 4800 bps, fall forward
when line improves.
&Gnn = 0, 1, or 2 Guard Tones (International model only)
*** &G0 Turn off ITU-T guard tones.
&G1 Turn on ITU-T 550 Hz guard tone.
&G2 Turn on ITU-T 1800 Hz guard tone.
Note: The U.K. model is locked to &G2, which turns
on the ITU-T 1800 Hz guard tone.
Hnn = 0 or 1 On-Hook/Off-Hook
H0 Go on-hook (hang up).
H1 Go off-hook.
*Hnn = 0 or 1 Busy-Out After Disconnect
*** *H0 Disable busy-out after disconnect.
*H1 Enable busy-out after disconnect.