MT3334HD8 User Guide
76 CommPlete Communications ServerCommand Values Description
$BAnn = 0 or 1 Baud Adjust
*** $BA0 Set baud adjust off, speed conversion on. (Serial
port speed is independent of modem data rate.)
$BA1 Set baud adjust on, speed conversion off.
(Serial port speed is same as modem data rate.)
&Cnn = 0, 1, 2, Carrier Detect Control
or 4 &C0 Force Carrier Detect on.
*** &C1 Let Carrier Detect follow carrier signal.
&C2 Let Carrier Detect drop for time set by S24 on
disconnect, then go high again.
&C4 Reset modem when Carrier Detect drops.
&CDnn = 0 or 1 Cleardown at Disconnect
*** &CD0 Enable cleardown.
&CD1Disable cleardown.
Dss = phone # Dial
Dial telephone number s, where s may include up to
60 digits and the T, P, R, comma, colon, and semicolon
characters.
DsNds = phone #
d = 0 or 1
Store Phone Number
To store, enter D followed by telephone number s,
then N followed by directory number d.
&Dnn = 0, 1, 2, Data Terminal Ready Control
or 3 &D0 Modem ignores DTR signal.
&D1 When DTR drops, the modem hangs up. While
DTR is low, the modem accepts commands but
will not dial or auto-answer until DTR goes high
again.
*** &D2 Same as &D1.
&D3 When DTR drops, the modem hangs up and
resets as if an ATZ or an AT&F command was
issued.
%DCnn = 0 or 1 Command Mode Control
*** %DC0 Enable command mode.
%DC1 Disable command mode.
%DFnn = 0 or 1 Line Probe Data Format
*** %DF0 V.34 line probe data displayed in graph format.
%DF1 V.34 line probe data displayed in table format.
%DPnn = 0 or 1 Line Probe Data Read
*** %DP0 Disable reading of line probe data during the
V.34 handshake.
%DP1 Enable reading of line probe data during the
V.34 handshake.