Multi-Tech Systems MT3334HD8 manual Configuration Storage and Recall Commands, NdNe Number Linking

MT3334HD8 User Guide

You can automatically dial a telephone number that is stored in the modem’s number memory by typing ATNn, where n = 0 or 1. For example, you can dial a number stored at N0 by typing ATN0 in terminal mode and pressing ENTER.

Warning: Do not include the letter D in this command, or the stored number will be erased.

NdNe Number Linking

d = 0 or 1 e = 1 or 0 Default: none

Number linking allows the modem to dial a second stored number if the first stored number is busy. (See the DsNd command.) This command is useful when a computer can be accessed through more than one phone number. However, it cannot be used with blind dialing, since busy signals would not be detected.

To link the number in memory location N0 to the number in N1, type ATN0N1 and press Enter. You can cycle back and forth between two numbers by linking them several times in one command: ATN0N1N0N1N0N1<CR>. The only limit on the number of times the modem can cycle between two numbersisthe60-charactermaximumallowedinacommandline.

LList Stored Telephone Numbers

Use the L command to display dialing commands stored in the modem’s nonvolatile memory. Typing ATL<CR> displays the stored N numbers in the following format:

0 T14082345678

1 P9,T14089876543

All digits and command letters are displayed. The N number is shown first, followed by the complete dialing command and telephone number as originally entered.

Configuration Storage and Recall Commands

The MT3334HD8 stores parameters in two places. It stores factory default parameters in read-only memory (ROM), and customized parameters in nonvolatile random access memory (NVRAM). You can- not change the default parameters in ROM; however, you can change parameters in temporary memory and then store them in NVRAM as custom settings. You can then recall the custom settings as if they were factory default settings.

&Wn Store Configuration

n = 0 or 1 Default: &W1

The &W command stores current AT commands and S-register values in nonvolatile memory, so you won’t lose your custom settings when you turn off the modem or reset it.

&W0 (or &W) stores all current AT command and S-register values in nonvolatile random access memory (NVRAM) and configures the modem so that it reads your custom settings in NVRAM when the modem is turned on or when it is reset with the Z command. (The &F reset command will continue to read the factory default settings in ROM unless you store the &F9 command.)

&W1 erases your custom settings in NVRAM when the modem is turned off or reset, causing the modem to read the factory default settings in ROM when it is subsequently turned on or reset.

For further information on how the &W command interacts with the reset commands, see Table 2.

20 CommPlete Communications Server