Multi-Tech Systems MT3334HD8 manual Command Values Description #Vn

				E AT Command Summary
	Command	Values	Description
	#Vn	n = 0 or 1	V.32terbo Handshake
		*** #V0		Enable V.32terbo tones in answer mode.
			#V1	Disable V.32terbo tones in answer mode.
	W	In dialing	Wait for New Dial Tone
		command	Causes modem to wait for new dial tone. (X2 or X4
			must be selected.)
	&Wn	n = 0 or 1	Store Configuration
			&W0	Store current settings in NVRAM; modem will
				load these at power-on or with the ATZ
				command instead of reading factory ROM
				defaults.
		***	&W1	Do not store settings.
	Xn	n = 0–4	Result Codes and Call Progress Selection
		***	X0	Basic result codes (CONNECT only); does not
				look for dial tone or busy.
			X1	Extended result codes (w/ CONNECT 1200,
				CONNECT 2400, etc.); does not look for dial
				tone or busy signal.
			X2	Extended result codes with NO DIAL TONE;
				does not look for busy signal.
			X3	Extended result codes with BUSY; does not look
				for dial tone.
			X4	Extended result codes with NO DIAL TONE
				and BUSY.
	#Xn	n = 0 or 1	Number of XOFF Characters Sent
		***	#X0	Single XOFF character sent after buffer is full.
			#X1	Multiple XOFF characters sent (one for every
				character received after buffer is full).
	Yn	n = 0 or 1	Long Space Disconnect
		***	Y0	Disable sending or responding to long space
				break signal on disconnect.
			Y1	Enable sending or responding to long space
				break signal on disconnect. (Both modems
				must have Y1 set.)
	Z	n/a	Modem Reset
			Reset modem to default values. Defaults come from
			NVRAM if &W0 is set, from ROM if &W1 is set.
,		In dial	Dialing Pause
		command	Comma; causes dialing pause for time set by S8.
:		At end of dial	Continuous Redial
		command	Colon; causes continuous redial of number until
			answered (10 in North American models). Not used in
			U.K. or International models.

CommPlete Communications Server 83