Multi-Tech Systems MT5634SMI V.92 Command Display Current Settings, Command \Bn Transmit Break

			Chapter 1 – AT Commands, S-Registers and Result Codes
Command:	&V	Display Current Settings
Values:		N/A
Description:		Displays the active modem settings.
Command:	&Wn	Store Current Configuration
Values:		n = 0 or 1
Default:		1
Description:		&W0	Stores current modem settings in non-volatile memory and causes them to
			be loaded at power-on or following the ATZ command instead of the
			factory defaults. See &F command.
		&W1	Clears user default settings from non-volatile memory and causes the
			factory defaults to be loaded at power-on or following the ATZ command.
Command:	&Zy=x Store Dialing Command
Values:		y = 0–2 (0–1SMI-Parallel {internal})
		x = Dialing command
Default:		None
Description:		Stores dialing command x in memory location y. Dial the stored number using the
		command ATDS=y. See Also the #CBS command, a callback security command.
Command:	\An	Select Maximum MNP Block Size
Values:		n = 0, 1, 2, or 3
Default:		3
Description:		\A0	64-character maximum
		\A1	128-character maximum
		\A2	192-character maximum
		\A3	256-character maximum
Command:	\Bn	Transmit Break
Values:		n = 0–9 in 100 ms units
Default:		3
Description:		In non-error-correction mode only, sends a break signal of the specified length to a
		remote modem. Works in conjunction with the \K command.

Multi-Tech Systems, Inc. SocketModem MT5634SMIxx Reference Guide (S000263C) 14