Multi-Tech Systems MT5634SMI V.34, MT5634SMI V.92 manual Data Reception, Session Termination

Chapter 3 – Fax Class 2 Commands

Data Reception

Class 2.1	+FDR
Syntax:	+FDR<CR>
	The +FDR command initiates transition to Phase C data reception. This can occur
	after answering, after dialing, after a document is received, or after a page is
	received.
	The modem may report the negotiated T.30 parameters with the remote ID and NSS
	frame information, if available. When the modem is ready to commence data transfer,
	it will issue a CONNECT response code. After the host receives the CONNECT
	response and the host is ready to accept data, it will issue a <DC2> character (12h)
	to the modem.

Class 2	+FDR
	Same as Class 2.1.

Session Termination

Class 2.1	+FKS
Syntax:	+FKS
	The +FKS command causes the modem to terminate the session in an orderly
	manner by sending a DCN message at the next opportunity and hanging up. At the
	end of the termination process, the modem will report the +FHS response with a
	result code, go on-hook, and set +FCLASS=0.
	This operation can also be invoked by using the <CAN> (cancel) character during
	Phase C data reception.

Class 2	+FK
Syntax:	+FK
	Essentially the same as Class 2.1.

Initialize Facsimile Parameters

Class 2.1	+FIP
Syntax:	+FIP
	The +FIP command causes the modem to initialize all Service Class 2.0/2.1 facsimile
	parameters to the default settings. This command does not change the setting of
	+FCLASS. It has the same effect as if the host had issued individual parameter
	setting commands.
	MultiModem modems do not support multiple profiles, and thus do not support the
	optional +FIP=<value> syntax documented in T.32.
Class 2	There is no equivalent command in Class 2.

Multi-Tech Systems, Inc. SocketModem MT5634SMIxx Reference Guide (S000263C) 63