Multi-Tech Systems MT5634SMI V.34 manual Command Dial, Command DS=y Dial Stored Telephone Number

			Chapter 1 – AT Commands, S-Registers and Result Codes
Command:	Ds	Dial
Values:		s = dial string (phone number and dial modifiers)
Default:		none
Description:		Dial telephone number s, where s may up to 40 characters long and include the 0–
		9, *, #, , B, C, and D characters, and the L, P, T, V, W, S, comma (,), semicolon (;),
		!, @, ^ and $ dial string modifiers.
		Dial string modifiers:
		L	Redial last number. (Must be placed immediately after ATD.)
		P	Pulse-dial following numbers in command.
		T	Tone-dial following numbers in command (default).
		V	Switch to speakerphone mode and dial the following number. Use ATH
			command to hang up.
		W	Wait for a new dial tone before continuing to dial. (X2, X4, X5, X6, or X7 must
			be selected.)
		,	Pause during dialing for time set in register S8.
		;	Return to command mode after dialing. (Place at end of dial string.)
		!	Hook flash. Causes the modem to go on-hook for one-half second, then off-
			hook again.
		@	Wait for quiet answer. Causes modem to wait for a ringback, then 5 seconds
			of silence, before processing next part of command. If silence is not detected,
			the modem returns a NO ANSWER code.
		^	Disable data calling tone transmission.
		$	Detect AT&T call card “bong” tone. The character should follow the phone
			number and precede the user’s call card number:
			ATDT1028806127853500$123456789
Command: DS=y Dial Stored Telephone Number
Values:		n = 0–2 (0–1 for SMI-Parallel {internal})
Default:		none
Description:		Dial a number previously stored in directory number y by the &Zy=x command.
		Example: ATDS=2
Command:	En	Echo Command Mode Characters
Values:		n = 0 or 1
Default:		1
Description:		E0	Do not echo keyboard input to the terminal.
		E1	Do echo keyboard input to the terminal.
Command:	Fn	Echo Online Data Characters
Values:		n = 1
Default:		1
		F0	Enable online data character echo. (Not supported.)
		F1	Disable online data character echo (included for backward compatibility with
			some software).
Command:	Hn	Hook Control
Values:		n = 0 or 1
Default:		0
Description:		H0	Go on-hook (hang up).
		H1	Go off-hook (make the phone line busy).

Multi-Tech Systems, Inc. SocketModem MT5634SMIxx Reference Guide (S000263C) 9