Appendices

Appendix C: Comprehensive Driver Notes

Introduction

This appendix provides general and specific information on the MT5634ZLX/E software drivers.

Notes for NDIS Driver

The following are examples of CONFIG.SYS file and AUTOEXEC.BAT for loading System Soft Card Services and NDIS2 driver:

Examples of CONFIG.SYS file:

device=c:\cardsoft \ss365sl.exe device=c:\cardsoft \cs.exe

device=c:\cardsoft \csalloc.exe c:\cardsoft\csalloc.ini device=c:\lanman.dos\drivers\Ethernet\lmmdis\carden.exe /iop=nnn /irq=n /com=n /mir=n device=c:\cardsoft \cardid.exe

device=c:\lanman.dos\deivers\protman.dos /i:c:\lanman.dos device=c:\lanman.dos\drivers\ Ethernet\lmndis\lmndis.dos

Examples of partial AUTOEXEC.BAT file:

set path= c:\lanman.dos\netprog;%path% net start workstation

load netbeui

The 10/100 Fast Ethernet function configuration information for the DOS NDIS driver is contained in the PROTOCOL.INI file. To make allowances for passing the requested modem COM port (1,2,3,4) to the driver, there has been another field added. The section of the PROTOCOL.INI file that contains configuration information for this card must begin with [LMNDIS_NIF]. The valid entries in the file are listed below:

[LMNDIS_NIF]

DRIVERNAME - LMNDIS$

This line must always be present

IOADDRESS - value

where value is one of the following address: 0x220, 0x300, 0x320, 0x340.

The leading 0x for the hex notation is required.

To have Card Services select the address base from it’s pool of available address then use a value of 0.

INTERRUPT - value

where values is one of the following interrupts: 3, 4, 5, 7, 9, 10, 11, 12, 15.

To have Card Services select an available interrupt resource then place a value of 0 at this location.

MT5634ZLX/E

61

Page 61
Image 61
Multi-Tech Systems MT5634ZLXE manual Appendix C Comprehensive Driver Notes Introduction, Lmndisnif Drivername LMNDIS$