GETTING STARTED
2.1 GETTING STARTED
Connecting all the devices to construct a surveillance.
1)Install HDD:
The HDD must be installed before the DVR is turned on.
2)Connect cameras.
3)Connect monitors.
4)Connect the external devices.
NOTE:
Please refer to Appendix #1 for HDD installation instructions.
NOTE:
Please refer to “Section 1.5 Rear Panel” for connection.
NOTE:
Please refer to Appendix#2 for pin configurations of the external I/O port .
5)Connect the AC power cord to power adapter and plug into an electrical outlet. The standby LED would be on as red.
Press the “POWER” button. The power LED will be on as red. It takes approximately 10 to 15 seconds to boot the system.
Take 16CH as an example
Available Capacity of
Internal HDDs
System Time
Under HDD Overwrite
Mode
Channel Title
10
