Multiquip DCA-150SSKII - GENERATOR SHUT-DOWN PROCEDURE, Engine Shutdown, Table of Contents

Table of Contents

DCA-150SSKII — GENERATOR SHUT-DOWN PROCEDURE

Engine Shutdown

To shut-down the generator use the following procedure:

1.Place both the MAIN, GFCI and LOAD circuit breakers to the "OFF position"

2.Turn the Engine Throttle Handle (Figure 63)to the left and push in to set the speed to 'low'.

Figure 63. Engine Throttle Lever (low)

3.If the generator is equipped with an idle control switch, set the switch to "OFF" positon. (Figure 64)

6.Verify that the "Engine Running" status LED (Figure

66)on the Microprocessor Engine Control Module (MPEC) display is "OFF" (not lit).

Figure 66. MPEC Engine Running

Status LED (OFF)

7.If the generator is equipped with an ignition switch, (Figure 67) turn the key to the left to the "OFF" positionturn off the engine.

Figure 67. Off/Manual Auto Switch (OFF)

Figure 64. Idle Control Switch (OFF)

8. Remove the load from the UNVO terminal strip (Figure 14 - page 33).

4.Let the engine cool by running it for 3-5 minutes with no load applied.

5.Place the Off/Manual/Auto Switch (Figure 65) in the "OFF/ RESET" position.

Figure 65. Off/Manual Auto Switch (OFF)

DCA-150SSKII — PARTS AND OPERATION MANUAL— REV. #1 (05/08/01) — PAGE 51