Multiquip DCA-150SSKII - GENERATOR START-UP PROCEDURE MANUAL, Before Starting, Battery, Engine

Models: DCA-150SSKII

1 92
Download 92 pages 7.3 Kb
Page 47
Image 47
DCA-150SSKII — GENERATOR START-UP PROCEDURE (MANUAL)

Table of Contents

DCA-150SSKII — GENERATOR START-UP PROCEDURE (MANUAL)

WARNING:

 

 

2. Once it is determined if commercial power is required,

 

 

connect the load to the UNV terminals as shown in

 

The engine's exhaust contains

Figure 43. These terminals can be found on the output

 

terminal panel, see page 33, Figure 14. To gain access

 

harmful emissions. ALWAYS ventilate

 

to the output terminals lift the UNV cover. Make sure to

 

the exhaust when operating inside

 

tighten terminal nuts securely to prevent load wires from

 

tunnels, excavations or buildings.

Before Starting

slipping out.

Direct exhaust away from nearby

Engine

 

 

 

1.Check the lubricating oil level prior to starting the engine. Make sure the generator is level. The oil level must be maintained between two notches on the dipstick.

2.When there is not enough lubricating oil, fill the crankcase with high grade motor oil. Use a high quality detergent oil classified CC or higher (See Table 12 on page 43).

3.Check the coolant level in the radiator and subtank. Replenish with antifreeze as necessary. Always maintain the coolant level between the FULL and LOW markings on the coolant container. Be sure that the radiator cap is fastened securely.

4.Check the fuel level on the fuel gauge. If fuel is low, fill the fuel tank with clean fresh unleaded automotive diesel. If diesel spillage occurs, completely wipe up the spilled fuel immediately.

Before Starting

Generator and Control Panel

Figure 43. UNV Terminal Lugs (Load)

3.Connect the negative battery cable (BLACK) to the negative post on the battery (Figure 44).

CAUTION:

NEVER start the engine with the main, GFCI or load circuit breakers in the ON position.

1.Be sure to disconnect the electrical load and switch the main, load and G.F.C.I. circuit breakers (Figure 42) to the “OFF” position prior to starting the engine.

Figure 42. Main, GFCI and

Load Circuit Breakers

NEGATIVE

POSTIVE

BATTERY

Figure 44. Battery Connections

DCA-150SSKII — PARTS AND OPERATION MANUAL— REV. #1 (05/08/01) — PAGE 47

Page 47
Image 47
Multiquip DCA-150SSKII - GENERATOR START-UP PROCEDURE MANUAL, Before Starting, Battery, Table of Contents, Engine