Service Tool Setup and Connection | Multiquip HTXD6i / STXD6i

SERVICE TOOL SETUP AND CONNECTION

WHITEMAN SERVICETOOL (WST) INSTALLATION

NOTICE

Make sure that the Sauer Danfoss Plus Software is already installed before proceeding with the Whiteman Service Tool (WST) installation.

1.Call or e-mail Multiquip Technical Support or Field Service to obtain the application specific Whiteman Service Tool (WST) file.

2.Also obtain software license key through Multiquip Technical Support or Field Service.

3.The WST file will be sent to you as an attachment to an e-mail.

4.Open the e-mail sent by Multiquip and click on the attachment. On the drop-down menu, select "Save Target As" (Figure 10).

Figure 10. Saving WST Application File

5.Do not change the file name. Save the file to your desktop.

6.Locate and verify that the WST application file (22708P) was saved to your desktop.

7.Double-click on the 22708P Icon on your desktop. One of the screens shown in Figure 11 will appear. Click "Cancel".

Navigation Bar	Click “Cancel”
is not populated

Navigation Bar	Click “Cancel”
is not populated

Figure 11. WST Navigation Bar (Not Populated)

8.Click "Cancel" again when the new screen (Figure 12) comes up.

Click cancel

Figure 12. WST Navigation Bar (Populated)

HTXD6i/STXD6i TROWEL • SETUP, ADJUSTMENTS AND CALIBRATIONS — REV. #1 (01/24/14) — PAGE 15

Image 15

Multiquip HTXD6i / STXD6i manual Service Tool Setup and Connection, Click Cancel again when the new screen comes up

Contents

This Manual Must Accompany the Equipment AT ALL Times Model HTXD6i/STXD6i HTX6Di/STX6Di Trowel Table of Contents Machine Information and Maintenance LOG Safety Messages Safety Information „ALWAYS know the location of the nearest General Safety Before servicing equipment Trowel SafetyEngine Safety Order Form PT-160 „ Use well-insulated gloves when picking up the battery Fuel SafetyBattery Safety „ Never tamper with the factory settings „ Always shutdown engine before transporting Transporting SafetyTowing Safety Lifting Environmental Safety Tools Needed Machine Information ModelSerial Number General Procedures Setup Jumper InstallationRemove Setup Jumper If installed Loosen 1-1/16 jam nut on charge relief valve Item A, Figure Initial Check and AdjustmentsOIL and Coolant Check Hydraulic Oil Check Engine Oil Engine CoolantEnsure engine is level Click Cancel again when the new screen comes up Service Tool Setup and Connection WST Tool Bar Input the license key obtained from Multiquip and click OK Necessary to crank or turn on the engine Laptop ConfigurationConnection Procedure Click Finish on the next screen to complete installation Click Calibration button in Pedal Sensor frame Figure Machine Setup and CalibrationSensor Adjustment Calibrate Foot Pedal Secondary Hydraulic Fill Procedures CalibrationPress Start button to begin calibration and follow prompts Restart machine Machine Pressure AdjustmentCharge Pressure Adjustment Pitch Pressure Check Pitch Pressure Adjustment Steering Pressure AdjustmentReturn engine rpm to idle Turn off machine and remove gauge Lower trowel and shut off Loosen Jamb nut Item D, Figure Trowel Speed ADJUSTMENT\SETUPAdjust Zero Stroke Position Left Side Trowel Speed Adjustment Right Side Trowel Speed Adjustment Remove setup jumper or re-enable stroke followerCalibrate Stroke Sensor Flatten Blades Pitch Setup Measure Blade Leading Edge Height Leading Edge Height Adjustment Pitch Sensor Calibration Set Zero Pitch Cylinder Stops Turn machine off for 10 seconds Gauge Inspection Fluid LevelsMechanical Static Blade Pitch Drift Test Switch smart pitch switch to off position Refer to for location on fuse panel Fuse InformationPage HERE’S HOW to GET Help