MACHINE SETUP AND CALIBRATION

b.Install 3.25” Gauge (P/N 32044) over both Left and Right Cylinders as shown in Figure 41.

3.25” GAUGE

Figure 41. Gauge Installation

c.Press Hard Ret. button to retract cylinder onto gauge.

d.Verify gauge is tight between cylinder body and clevis.

e.Press “Set T1” button (Figure 42).

Figure 42. Start Pitch Sensor Calibration

g.Press Hard Ext. Button to fully extend pitch cylinders.

h.Remove gauge.

6.Set Calibration Point 2.

a.Install 2.25” Gauge P/N 32000 over both Left and Right Cylinders as shown in Figure 41.

b.Press Hard Ret. Button to retract cylinder onto gauge.

c.Verify gauge is tight between cylinder body and clevis.

d.Press “Set T2” Button.

e.Record values on Machine Information and Maintenance Log in Machine Setup section.

f.Press Hard Ext. Button to fully extend pitch cylinders.

g.Remove gauge.

7.Set Calibration Point 3.

a.Ensure Hard Ext. is active and pitch cylinders are fully extended.

b.Press “Set L1” button.

c.Record values on Machine Information and Maintenance Log in Machine Setup section.

8.Set Calibration Point 4.

a.Press Hard Ret. button to fully retract cylinders, ensure yoke is against zero pitch stop.

b.Press Soft Ext. button, and wait until yoke is pressing against thrust collar.

c.Press “Set L2” button.

d.Record values on Machine Information and Maintenance Log in Machine Setup section.

9.Once calibrated, move pitch thru range ensuring calibrated signal moves from 0 to 100%.

10.Turn machine off for 10 seconds.

f.Record values on Machine Information and Maintenance Log in Machine Setup section.

HTXD6i/STXD6i TROWEL • SETUP, ADJUSTMENTS AND CALIBRATIONS — REV. #1 (01/24/14) — PAGE 27

Page 27
Image 27
Multiquip HTXD6i / STXD6i manual Gauge, Turn machine off for 10 seconds