Laptop Configuration | Multiquip HTXD6i / STXD6i specification

LAPTOP CONFIGURATION

CONNECTION PROCEDURE

NOTICE

Make sure that the Sauer Danfoss Plus Software and Whiteman Service Tool (WST) are installed before proceeding with the connection procedure.

1.Plug the CAN Gateway cable to the trowel at the service port (Figure 16). Do not connect laptop at this time.

4.When the CAN Gateway cable is connected to the laptop for the first time, it is necessary to install the CAN driver software. The installation screen will appear (Figure 19). Click "Next" to install the software automatically (default).

Figure 16. CAN Gateway Cable to Service Port

2.On the trowel, turn the ignition key to the ON position (Figure 17). This will turn on the MCU. It is not

necessary to crank or turn on the engine.

OFF

ACCON

CRANK

Figure 17. Ignition Key ON

3.Connect the USB connector of the CAN Gateway cable to the USB port (Figure 18).

Figure 18. Connecting the Laptop

Figure 19. CAN Driver Installation

5.Click "Finish" on the next screen (Figure 20) to complete installation.

Figure 20. CAN Driver Installation Complete

6.On the Service Tool software on your laptop, the main screen should show Firmware info loaded from trowel MCU and the Machine Status box shows lamps lit (Figure 21).

Figure 21. Service Tool Main Screen

HTXD6i/STXD6i TROWEL • SETUP, ADJUSTMENTS AND CALIBRATIONS — REV. #1 (01/24/14) — PAGE 17

Image 17

Multiquip HTXD6i / STXD6i manual Laptop Configuration, Connection Procedure, Necessary to crank or turn on the engine

Contents

This Manual Must Accompany the Equipment AT ALL Times Model HTXD6i/STXD6i HTX6Di/STX6Di Trowel Table of Contents Machine Information and Maintenance LOG Safety Messages Safety Information „ALWAYS know the location of the nearest General Safety Engine Safety Trowel SafetyOrder Form PT-160 Before servicing equipment Battery Safety Fuel Safety„ Never tamper with the factory settings „ Use well-insulated gloves when picking up the battery Towing Safety Transporting SafetyLifting „ Always shutdown engine before transporting Environmental Safety Tools Needed Serial Number Machine InformationModel Remove Setup Jumper If installed General ProceduresSetup Jumper Installation OIL and Coolant Check Initial Check and AdjustmentsHydraulic Oil Check Loosen 1-1/16 jam nut on charge relief valve Item A, Figure Ensure engine is level Engine OilEngine Coolant Click Cancel again when the new screen comes up Service Tool Setup and Connection WST Tool Bar Input the license key obtained from Multiquip and click OK Connection Procedure Laptop ConfigurationClick Finish on the next screen to complete installation Necessary to crank or turn on the engine Sensor Adjustment Machine Setup and CalibrationCalibrate Foot Pedal Click Calibration button in Pedal Sensor frame Figure Press Start button to begin calibration and follow prompts Secondary Hydraulic Fill ProceduresCalibration Charge Pressure Adjustment Machine Pressure AdjustmentPitch Pressure Check Restart machine Return engine rpm to idle Turn off machine and remove gauge Pitch Pressure AdjustmentSteering Pressure Adjustment Adjust Zero Stroke Position Trowel Speed ADJUSTMENT\SETUPLeft Side Trowel Speed Adjustment Lower trowel and shut off Loosen Jamb nut Item D, Figure Calibrate Stroke Sensor Right Side Trowel Speed AdjustmentRemove setup jumper or re-enable stroke follower Flatten Blades Pitch Setup Measure Blade Leading Edge Height Leading Edge Height Adjustment Pitch Sensor Calibration Set Zero Pitch Cylinder Stops Turn machine off for 10 seconds Gauge Mechanical InspectionFluid Levels Static Blade Pitch Drift Test Switch smart pitch switch to off position Refer to for location on fuse panel Fuse InformationPage HERE’S HOW to GET Help