Multiquip HTXD6i / STXD6i manual Tools Needed

TOOLS NEEDED

The specialized tools listed in Table 1 are required to maintain and service the HTXD6i and STXD6i ride-on trowels. Fleet technicians and servicing dealers must have these tools for efficient unit setup and component calibration.

Table 1. Setup, Calibration, and Diagnostic Tools

TOOL	DESCRIPTION	PART NO.	QTY
Tool Kit	Includes all tools listed below.	32062	1

	Required to interface to the trowel MCU.
CAN Gateway Cable	Required for foot pedal calibration, pitch	22882	1
	sync calibration, stroke cylinder calibration,
	engine fault code reading, diagnostics, ETC.

	Used in calibrating one of the two blade pitch
Gauge Tool (3.25”)	set points as part of the synchronization	32044	2
	process.

	Used in calibrating one of the two blade pitch
Gauge Tool (2.25”)	set points as part of the synchronization	32000	2
	process.

	Used to place the engine at full speed for
Set Up Jumper	component calibration and to simultaneously	32007	1
	disable both the stroke follower and cold
	start mode.

	Used to help set the foot pedal sensor. It is
Pedal Wrench	also used for setting the Zero Pitch Cylinder	32020	1
	Stops by using the thickness of the wrench.

PAGE 10 — HTXD6i/STXD6i TROWEL • SETUP, ADJUSTMENTS AND CALIBRATIONS — REV. #1 (01/24/14)