Model HTXD6i/STXD6i

SETUP, ADJUSTMENTS AND CALIBRATIONS

SERIES

HYDRAULIC RIDE-ON TROWEL

(YANMAR 4TNV84T-Z-DSA2 DIESEL ENGINE)

Revision #1 (01/24/14)

To find the latest revision of this publication, visit our website at: www.multiquip.com

THIS MANUAL MUST ACCOMPANY THE EQUIPMENT AT ALL TIMES.

PN: 32399

Page 1

Image 1

Multiquip HTXD6i / STXD6i manual Model HTXD6i/STXD6i, This Manual Must Accompany the Equipment AT ALL Times

Contents

This Manual Must Accompany the Equipment AT ALL Times Model HTXD6i/STXD6i HTX6Di/STX6Di Trowel Table of Contents Machine Information and Maintenance LOG Safety Messages Safety Information „ALWAYS know the location of the nearest General Safety Engine Safety Trowel SafetyOrder Form PT-160 Before servicing equipment Battery Safety Fuel Safety„ Never tamper with the factory settings „ Use well-insulated gloves when picking up the battery Towing Safety Transporting SafetyLifting „ Always shutdown engine before transporting Environmental Safety Tools Needed Model Machine InformationSerial Number Setup Jumper Installation General ProceduresRemove Setup Jumper If installed OIL and Coolant Check Initial Check and AdjustmentsHydraulic Oil Check Loosen 1-1/16 jam nut on charge relief valve Item A, Figure Engine Coolant Engine OilEnsure engine is level Click Cancel again when the new screen comes up Service Tool Setup and Connection WST Tool Bar Input the license key obtained from Multiquip and click OK Connection Procedure Laptop ConfigurationClick Finish on the next screen to complete installation Necessary to crank or turn on the engine Sensor Adjustment Machine Setup and CalibrationCalibrate Foot Pedal Click Calibration button in Pedal Sensor frame Figure Calibration Secondary Hydraulic Fill ProceduresPress Start button to begin calibration and follow prompts Charge Pressure Adjustment Machine Pressure AdjustmentPitch Pressure Check Restart machine Steering Pressure Adjustment Pitch Pressure AdjustmentReturn engine rpm to idle Turn off machine and remove gauge Adjust Zero Stroke Position Trowel Speed ADJUSTMENT\SETUPLeft Side Trowel Speed Adjustment Lower trowel and shut off Loosen Jamb nut Item D, Figure Remove setup jumper or re-enable stroke follower Right Side Trowel Speed AdjustmentCalibrate Stroke Sensor Flatten Blades Pitch Setup Measure Blade Leading Edge Height Leading Edge Height Adjustment Pitch Sensor Calibration Set Zero Pitch Cylinder Stops Turn machine off for 10 seconds Gauge Fluid Levels InspectionMechanical Static Blade Pitch Drift Test Switch smart pitch switch to off position Refer to for location on fuse panel Fuse InformationPage HERE’S HOW to GET Help