WST Tool Bar | Multiquip HTXD6i / STXD6i instruction

SERVICE TOOL SETUP AND CONNECTION

9.The new screen will have both navigation and tool bars active (Figure 13.)

Figure 13. WST Tool Bar

10.Click on "Tools". On the drop-down menu, click on "License Manager" (Figure 14).

Figure 14. WST License Manager

11.Input the license key obtained from Multiquip (Figure 15) and click "OK".

Figure 15. Entering License Key

PAGE 16 — HTXD6i/STXD6i TROWEL • SETUP, ADJUSTMENTS AND CALIBRATIONS — REV. #1 (01/24/14)

Page 16

Image 16

Multiquip HTXD6i / STXD6i manual Input the license key obtained from Multiquip and click OK, WST Tool Bar

Contents

Model HTXD6i/STXD6i This Manual Must Accompany the Equipment AT ALL Times Table of Contents HTX6Di/STX6Di Trowel Machine Information and Maintenance LOG Safety Information Safety Messages General Safety „ALWAYS know the location of the nearest Trowel Safety Engine SafetyOrder Form PT-160 Before servicing equipment Fuel Safety Battery Safety„ Never tamper with the factory settings „ Use well-insulated gloves when picking up the battery Transporting Safety Towing SafetyLifting „ Always shutdown engine before transporting Environmental Safety Tools Needed Model Machine InformationSerial Number Setup Jumper Installation General ProceduresRemove Setup Jumper If installed Initial Check and Adjustments OIL and Coolant CheckHydraulic Oil Check Loosen 1-1/16 jam nut on charge relief valve Item A, Figure Engine Coolant Engine OilEnsure engine is level Service Tool Setup and Connection Click Cancel again when the new screen comes up Input the license key obtained from Multiquip and click OK WST Tool Bar Laptop Configuration Connection ProcedureClick Finish on the next screen to complete installation Necessary to crank or turn on the engine Machine Setup and Calibration Sensor AdjustmentCalibrate Foot Pedal Click Calibration button in Pedal Sensor frame Figure Calibration Secondary Hydraulic Fill ProceduresPress Start button to begin calibration and follow prompts Machine Pressure Adjustment Charge Pressure AdjustmentPitch Pressure Check Restart machine Steering Pressure Adjustment Pitch Pressure AdjustmentReturn engine rpm to idle Turn off machine and remove gauge Trowel Speed ADJUSTMENT\SETUP Adjust Zero Stroke PositionLeft Side Trowel Speed Adjustment Lower trowel and shut off Loosen Jamb nut Item D, Figure Remove setup jumper or re-enable stroke follower Right Side Trowel Speed AdjustmentCalibrate Stroke Sensor Pitch Setup Flatten Blades Leading Edge Height Adjustment Measure Blade Leading Edge Height Set Zero Pitch Cylinder Stops Pitch Sensor Calibration Gauge Turn machine off for 10 seconds Fluid Levels InspectionMechanical Switch smart pitch switch to off position Static Blade Pitch Drift Test Fuse Information Refer to for location on fuse panelPage HERE’S HOW to GET Help