National Instruments 370769C-01 Putting Information in Table Format

Appendix C Generating 2167A Documents Using FrameMaker

4. Click Copy File into Document.

5. Select Controller_Logic_mil.mml and click OK.

6. After the import is complete, you will still have a blank page except for

a single paragraph text symbol at the top of the page. Select the

paragraph symbol and delete it. The Software Design Document title

page will fill the page.

Note Do not save this file until you are prompted to do so.

Putting Information in Table Format

Page through the document to ensure it meets your needs. If you have

information that you want to be in table format, complete the following

steps, beginning with step1. If you have no tables, skip to step6.

Select all the data you want to include in the table, but do not include the

last paragraph symbol in the last row of table data. Refer to Figure C-3 for

an example of exactly what information you need to select for reformatting.

Figure C-3. Marking Data for Table Formatting

1. From the pull-down menu, select Table»Convert to Table. When the

Convert to Table dialog appears, leave the settings intact and click OK.

2. From the pull-down menu, select Table»Resize Columns. When the

Resize Columns dialog appears, click By Scaling to Widths

Totalling. Change the value to 6.25 inches and click OK. Make sure

that the whole table is selected when you do this. At this point, you can

resize individual columns if necessary.

Do not include last

paragraph symbol

Table Data

of table data