Appendix D Generating 2167A Documents Using Interleaf
DocumentIt User Guide D-8 ni.com
Adding a Plot or SystemBuild Diagram to an Interleaf Document
1. To place a plot or SystemBuild diagram in your Interleaf document,
complete the following steps:
a. Use the hardcopy command to create a PostScript file of each
plot or SystemBuild diagram you want to i nclude.
b. Convert each PostScript file to an Interleaf image file. The
following diagram illustrates the conversion process (using
psfilt) for each PostScript file.
Run each PostScript file through the Interleaf psfilt filter by
selecting Custom»Misc»psfilt.
Note If the psfilt filter is not set up, refer to your Interleaf manual for instructions.
2. Use the include_img segment to add the image to your generated
document. Refer to Chapter 3 of the Template Programming
Language User Guide for information about include_imG. Complete
the following steps:
a. At the bottom of the $ISIHOME/
platform
/case/DIT/
templates/ileaf/milstd/ilmil.tpl template file is a
SEGMENT include_img line. ExampleD-1 shows a portion of
this SEGMENT section. Details of the frame itself are omitted.
Include this SEGMENT section in your own TPL file.
Example D-1 Example of include_img in TPL File
@SEGMENT include_img()@
<Frame,
Name = "floating",
Placement = Following Anchor,
Horizontal Alignment = Center,
Width = 6.50 Inches,
Width = Page Without Margins,
Height = 9 Inches,
Height = Page Without Margins,
file.ps psfilt file.ps1.img