Figure 22. New/Edit Address
Two levels of access may be assigned.
Read | |
| except the Access Control settings, but cannot |
| alter anything |
Read/Write | The user may read and alter all settings |
|
|
Enter your IP address and then set your own access rights to Read/Write (see the following note).
Note: Do not set all the stations in the Access Control table to Read. Once this is set and enabled, it will be impossible to modify the AP settings via IWMS. Should this situation occur, press the hardware Reset Button to restore the factory configuration.
To set a stations access rights, enter a station’s IP address and community string (the community string is used as a password to access the WWB or WEC) and choose Read or Read/Write.
