NEC LT150/LT85 user manual Basic Operation, Selecting the computer or video source, Volume control

Basic Operation

Selecting the computer or video source

SOURCE	AUTO
	ADJ.

Each time the Source button is pressed, the input source will change as follows:

→RGB → Video → S-Video → PC Card Viewer 

If no input signal is present, the input will be skipped.

Source display

Optimizing RGB image automatically

Press the Auto Adjust button to optimize an RGB image automati- cally.

SOURCE	AUTO
	ADJ.

Press the Auto Adjust button to fine-tune the computer image or to remove any vertical banding that might appear and to reduce video noise, dot interference or cross talk (this is evident when part of your image appears to be shimmering). This function adjusts the clock frequencies that eliminate the horizontal banding in the image. This function also adjusts the clock phase to reduce video noise, dot inter- ference or cross talk. (This is evident when part of your image ap- pears to be shimmering.)

This adjustment may be necessary when you connect your computer for the first time.

NOTE: The Auto Adjust function does not work for component signal.

Volume control

Sound level from the speaker on the projector can be adjusted.

NOTE: When the menu or the pointer appears, you cannot adjust the volume.

	increase volume
Vol.	Volume bar

SELECT

Vol.

decrease volume

Turning off picture and sound

Press the Picture Mute button to turn off the image and sound for a short period of time. Press again to restore the image and sound.

PIC.

MUTE

Getting Help about how to operate the projector

You get the contents about Help.

		U
		N
	M	E
HELP			Vol.
			SELECT
Display Help	E		Vol.			E	L
	N				C
	T			N
		E
				A
		R
				C

Exit Help

E–30