NetComm V110 Getting to know your NetComm V2xx ATA, Ports and Buttons, Port / Button Description

Getting to know your NetComm V2xx ATA

It is recommended that you take a moment to acquaint yourself with the indicator lights, ports and default settings of the V2xx ATA prior to commencing with installation.

Ports and Buttons

V110 (WAN + 1 LAN + 1 FXS)

V220 (WAN + 1 LAN + 2 FXS)

V211 (WAN + 1 LAN + 1 FXO +1 FXS)

	V210P (WAN + 1 LAN + 1 PSTN pass through +1 FXS)
Port / Button	Description
Power	Connect the supplied power adapter to the ATA. The power requirement is DC12 volts/0.6 A
	Note: Using a power supply with a different voltage rating will damage this product
Power Switch	Power on/off the NetComm ATA.
WAN Port	Connect to Broadband devices, such as an ADSL or Cable modem.
LAN Port	Connect to Ethernet network devices, such as a PC, switch, or router. Depending on the
	connection, you may need a cross over cable or a straight through cable
RESET	The Reset button will set the NetComm ATA to its factory default setting and reset the unit.
	You may need to reset the NetComm ATA into its factory defaults if you loose the ability to
	enter the NetComm ATA via the web interface, or following a software upgrade.
LINE Socket	Connect a telephone cable between the NetComm ATA line jack and a wall jack.
PHONE Socket	Connect a standard telephone handset to the NetComm ATA phone jack using a telephone cable.

V110,V2�10P,V2�11,V220� User Guide	YML881Rev1
	www.netcomm.com.au