Network Technologies CS-16/8 Terminal Command Guide, Commands Supported in Ascii Personalities

NTI RACK MOUNT CONSOLE TERMINAL WITH CONSOLE SWITCH

4.4 TERMINAL Command Guide

4.4.1 Commands Supported in ASCII Personalities

Table 8 lists all the ASCII commands recognized by the terminal. The native mode code for the command is given in the second column. (The native mode includes WY-325,WY-120 and WY-60.) The remaining columns show the support for the command in other ASCII personalities according to the following notations:

Same

Same as native code (code is native to other terminal also)

Wyse

Same as native code (Wyse enhancement- code not native to other terminal)

ENH

Same as native code when enhance mode is ON (Wyse enhancement - code not native to other terminal) A code listed under a nonnative personality indicates that the related terminal's native code is supported.

A blank in any column indicates that the command is not supported.

Variables are shown in italics. Their values are listed in alphabetical order at the end of the table.

Footnotes are found at the end of Table 7 on page 52.

Table 7- Commands Supported in ASCII Personalities

			Command
	Native	Wyse	ADDS	TVI		PC
FUNCTION
	Mode	WY-50+	VP A2	910+/925		Term
Monitor Mode
Monitor mode on	ESC U	Same		Same		Same
Monitor mode off	ESC u	Same		Same		Same
	or ESC X					Same
Selecting Personalities
Enhance mode off	ESC ~ SPACE	Same	ENH	ENH	ESC v SPACE
Enhance mode on	ESC ~ !	Same	ENH	ENH		ESC v !
Select WY-50+ mode	ESC ~"	Same	ENH	Wyse		ESC v "
Select TVI 910+ mode	ESC ~ #	Same	ENH	Wyse		ESC v #
Select TVI 925 mode	ESC ~ $	Same	ENH	Wyse		ESC v $
Select ADDS VP A2 mode	ESC ~ %	Same	ENH	Wyse		ESC v %
Select Console ANSI mode	ESC ~ A	Same	ENH	Wyse		ESC v A
Select Native mode	ESC ~ 4	Same	ENH	Wyse		ESC v 4
Select PC Term mode	ESC ~ 5	Same	ENH	Wyse		ESC v 5
Select VT52 mode	ESC ~ 6	Same	ENH	Wyse		ESC v 6
Select VT100 mode	ESC ~ ;	Same	ENH	Wyse		ESC v ;
Select PCGAPHIC mode*1	ESC ~ I	Same	ENH	Wyse		ESC v I
Select VT220-7 mode	ESC ~ <	Same	ENH	Wyse		ESC v <
Select VT220-8 mode	ESC ~ =	Same	ENH	Wyse		ESC v =
Select WY-325 mode*3	ESC ~ B	Same	ENH	Wyse		ESC v B
Communicating with the
computer
Enable transmission	CTRL Q	Same	Same	Same		Same
Stop transmission Disconnect	CTRL S	Same	Same	Same		Same
Send ACK (if ACK mode on)	CTRL E	Same		Wyse		Same

46