If you have any problems with your Computer: First check this manual to be sure you have followed the assembly instructions correctly.
Computer Installation:Follow Step 9 on page 10 of the Owner's Manudi
Computer Tube Assembly: Follow Step 6 on page 9 of thisManual
(Make sure all wire connectors ore firmly attached and 'click" into place).
If the Computer is powered by batteries and:
The Computer does not illuminate at all
•Reconnect the (10) wire connector at the base of the Computer and
the (5] wire connector inside the Computer Tube.
•Reinstall the batteries using ir_struotions on page 10,step 9.
Upon start-up the Computer's LCD display lllumlr_ates faintly
•Install new batteries, Although the batteries are new when they are shipped from the factory, over time they will slowly discharge.
The Computer displays "E t"
•Make sure the (5) wire connector inside the Computer Tube is securely fastened.
If the Computer is powered by the AC Adapter and:
The Computer does not illuminate at all
•Reconnect the (10) wire connector at the base of the Computer
and the (5) wire connector Inside the Computer Tube.
The Computer displays "E 1"
•Make sure the (5) wire connector inside the Computer Tube is securely fastened.
NOTE: ff the AC Adapter receptacle L_plugged into the Computer, but the adapter is not plugged into an AC wall outlet (or has been removed)
from the AC wall outlet, the Computer will _.To reset the
Computer, the AC Adapter must be plugged into the AC wall odilet.
If the Computer is powered by Batteries or
AC Adapter and:
The Computer is illuminated but does not display Speed or Distance
•Reconnect the (10) wire connector at the base of the Computer and
the the (2) wire connector Inside the Computer Tube.
The Computer is illuminated but does not display a pulse reading
•You nlust press the START button on the Computer, and have both
hands placed firmly on the Pulse Sensors on the Rear Handlebar for
the Computer to detect and display your pulse,
NOTE: Depending on what program you have set the Computer to, after
pressing the START butlon,it will take the Computer approximately 6
of the PuLse Sensor, the Computer will stop displaying your pulse.
NOTE: Keeping your Pulse Sensors cleon will provide better conductivity
between your hands, and the Pulse Sensor.
To insure a more accurate pulse reading, both hands must grab the Pulse
Sensors on the Rear Handlebar conlJnuously for appmxlmately 6 seconds.
2 (2) wire connectors connect
Pulse Sensors
(t0) wire connector leads to
the motor/magnetic sensor/
AC adapter jack
computer tube
main | (3) wire | connector |
frame | to AC | Adapter |
| receptacle | |
_'_18
