Clearances For Model | New Buck Corporation 85 specs

CLEARANCES FOR MODEL 85

CLEARANCES FOR MODEL 85

MINIMUM CLEARANCES TO COMBUSTIBLES

FREE-STANDING

BACK WALL

			8"
	B	C	F
	B	C
WALL	8"
SIDE	8"
SIDE
	HEARTH PAD			16"
	HEARTH PAD
	AB

DCD C

				Figure 9
MODEL	A	B	C	D
MODEL 85	24"	24"	25"	16"

NOTE: All clearances are to combustibles without low clearance shields and using single wall pipe and minimum floor protector. Clearances above may be reduced. Follow NFPA-211codes if available or follow instructions on next page.

* Floor Protector at rear needed for thru-the-wall exit only.

21

Image 23

New Buck Corporation 85 installation instructions Clearances For Model, Minimum Clearances To Combustibles Free-Standing

Contents

Page Page TABLE OF CONTENTS Page IMPORTANT INSTRUCTIONS INSTALLATION, OPERATION, ANDMAINTENANCE INSTRUCTIONS MODEL READ THIS FIRST INTRODUCTION SECTION MODEL SECTION MASONRY INSERT INSTALLATION Required Thickness MINIMUM CLEARANCESK* FACTORS OF ALTERNATE MATERIALS Material INSTALLATION PREPARATION FIREPLACE POSSIBLE TOOLS NEEDED FOR INSTALLATION Mounting the Trim Panels Installation Procedure Positioning the Heater Final Check Final Check 5.Check for smoke leaks around the doors SECTION PRE-FABINSERT INSTALLATION MINIMUM CLEARANCE TO COMBUSTIBLE MATERIAL SECTION RESIDENTIAL FREE-STANDINGINSTALLATIONPREPARING THE STOVE FOR INSTALLATION Required Thickness ALTERNATE FLOOR PROTECTORS MATERIALK* FACTORS OF ALTERNATE MATERIALS Material DETERMINING THE CHIMNEY LOCATION Chimney B.Wall Exit Into Metal Tee-Box C. Wall Exit Into Masonry Using Single Wall Pipe D. Ceiling Exit-CloseClearance ALCOVE INSTALLATION CLEARANCES FINAL CHECK MINIMUM CLEARANCES TO COMBUSTIBLES FREE-STANDING CLEARANCES FOR MODEL CLEARANCES FOR MODEL Optional MODEL 85 INSTALLATION OF CLOSE CLEARANCE SHIELDS SECTION FREE-STANDINGMOBILE HOME INSTALLATIONFOR MINIMUM CLEARANCES SEE PAGE FLOOR PROTECTION CHIMNEY PREPARING THE ROOM HEATER LOCATION TOOLS FOR INSTALLATIONPREPARING THE HEATER FOR INSTALLATION WARNING DO NOT INSTALL IN A SLEEPING ROOM 5.Next, remove the four 4 screws holding the heater to the stand. Position heater out of the way of the installation area Ceiling Exit Using Close Clearance Listed Chimney FINAL CHECK SECTION WOOD HEATER SAFETY SECTION OPERATION BUILDING A FIRE ROOM AIR BLOWER OPERATION POSSIBLE CAUSE TROUBLESHOOTINGPROBLEM SOLUTION MODEL WOOD STOVE EPA COMPLIANCE STATUS REPLACEMENT PARTS FOR THE MODEL PRODUCTS NOT COVERED WARRANTY TIME PERIODSPROCEDURE PRODUCTS COVERED OTHER RIGHTS CONDITIONS AND EXCLUSIONS