Possible Tools Needed For Installation | New Buck Corporation 85

POSSIBLE TOOLS NEEDED FOR INSTALLATION

POSSIBLE TOOLS NEEDED FOR INSTALLATION

If you decide to install your own stove, there are several hand tools you may need to do the job. If you do not already have them, they are readily available at most hardware stores.

Caulking gun

Large adjustable wrench (may not be needed)

Drop Cloths

Vacuum cleaner or whisk broom

Flashlight

1tube of RTV silicone, Code 103 or 106, or high temperature rubber cement rated between 450o F. - 600o F.

7/32" drill bit and drill Socket/Ratchet Set

Insulation (provided in trim kit package)

INSTALLATION PREPARATION

FIREPLACE

1.Locate furniture and other materials away from the front of the fireplace to allow free access to the fireplace.

2.Cover the hearth and adjacent floor areas with the drop cloth to protect from soiling or marring the surface.

3.Remove the existing fireplace damper plate.

4.Thoroughly clean the fireplace of ashes and soot.

5.If the fireplace has an ash dump or outside air provision, these must be sealed off with metal or tightly packed non-combustible insulation to prevent this cold air from entering the fireplace chamber.

7

Image 9

New Buck Corporation 85 Possible Tools Needed For Installation, Installation Preparation Fireplace

Contents

Page Page TABLE OF CONTENTS Page MAINTENANCE INSTRUCTIONS MODEL INSTALLATION, OPERATION, ANDREAD THIS FIRST IMPORTANT INSTRUCTIONS INTRODUCTION SECTION MODEL SECTION MASONRY INSERT INSTALLATION K* FACTORS OF ALTERNATE MATERIALS MINIMUM CLEARANCESMaterial Required Thickness INSTALLATION PREPARATION FIREPLACE POSSIBLE TOOLS NEEDED FOR INSTALLATION Mounting the Trim Panels Installation Procedure Positioning the Heater Final Check Final Check 5.Check for smoke leaks around the doors SECTION PRE-FABINSERT INSTALLATION SECTION RESIDENTIAL FREE-STANDINGINSTALLATION PREPARING THE STOVE FOR INSTALLATIONMINIMUM CLEARANCE TO COMBUSTIBLE MATERIAL K* FACTORS OF ALTERNATE MATERIALS ALTERNATE FLOOR PROTECTORS MATERIALMaterial Required Thickness DETERMINING THE CHIMNEY LOCATION Chimney B.Wall Exit Into Metal Tee-Box C. Wall Exit Into Masonry Using Single Wall Pipe D. Ceiling Exit-CloseClearance ALCOVE INSTALLATION CLEARANCES FINAL CHECK MINIMUM CLEARANCES TO COMBUSTIBLES FREE-STANDING CLEARANCES FOR MODEL CLEARANCES FOR MODEL Optional MODEL 85 INSTALLATION OF CLOSE CLEARANCE SHIELDS FOR MINIMUM CLEARANCES SEE PAGE FLOOR PROTECTION FREE-STANDINGMOBILE HOME INSTALLATIONCHIMNEY SECTION PREPARING THE HEATER FOR INSTALLATION TOOLS FOR INSTALLATIONWARNING DO NOT INSTALL IN A SLEEPING ROOM PREPARING THE ROOM HEATER LOCATION 5.Next, remove the four 4 screws holding the heater to the stand. Position heater out of the way of the installation area Ceiling Exit Using Close Clearance Listed Chimney FINAL CHECK SECTION WOOD HEATER SAFETY SECTION OPERATION BUILDING A FIRE ROOM AIR BLOWER OPERATION PROBLEM TROUBLESHOOTINGSOLUTION POSSIBLE CAUSE MODEL WOOD STOVE EPA COMPLIANCE STATUS REPLACEMENT PARTS FOR THE MODEL PROCEDURE WARRANTY TIME PERIODSPRODUCTS COVERED PRODUCTS NOT COVERED OTHER RIGHTS CONDITIONS AND EXCLUSIONS