For Connection via Home Wireless LAN
Configuring the CameraThis section describes the “Configuration Procedure” (c 134) in detail.
•To display more information on each step, click [Help]. To cancel configur- ing a profile device, click [Cancel].
1 Prepare a wireless
2 Install the Setup Utility to the computer.
Check whether the Setup Utility (c 131) is installed on the computer used for configuring.
3 Check that the USB setting is correctly selected in the camera and the battery is not exhausted, and turn off the camera.
Check the following before starting the Setup Utility on the computer. After checking is complete, turn off the camera.
•[Interface] > [USB] (c 126) is set to [PTP].
•The battery is fully charged or the supplied AC adapter is connected. If the battery runs out while configuring a profile, settings will not be entered correctly.
USB
PTP
Mass storage
Exit
Mode Transfer Wireless
4 Connect the computer and camera using the USB cable.
Place the camera in the
136