Nilfisk-Advance America 5200B manual Use, Fuses, Accessories/Options

INSTRUCTIONS FOR USE

Hydraulic diagram (See Fig. AG)

1.Hydraulic oil tank

2.Hydraulic oil filter

3.Hydraulic pump

4.Motor

5.Safety valve

6.Hopper lifting cylinder

FUSES

Under the hood, outside the electrical box, there are the following fuses:

–Thermal circuit breakers, which can be reset by pressing the related key:

–Main broom motor (5, Fig. V)

–Right side broom motor (6, Fig. V)

–Left side broom motor (7, Fig. V)

–Lamellar fuses, protected by a transparent plastic lid, protect the indicated circuits:

–F1 (15 A) (the first starting from above): Ignition switch

–F2 (20 A): Hydraulic pump

–F3 (10 A): Hopper actuator

–F4 (15 A): Filter shaker

–F5 (10 A): Services

–F6 (10 A): Working lights (optional)

–Spare 1 (20 A)

–Spare 2 (15 A)

Inside the electrical box (12, Fig. V), there is the following fuse:

–F0 (150 A): Main (2, Fig. Z)

ACCESSORIES/OPTIONS

In addition to the standard components, the machine can be equipped with the following accessories/options, according to the machine specific use:

–Main and side brooms with harder and softer bristles;

–Antistatic polyester or polyester BIA C dust filter;

–Pocket filter;

–Pivoting light;

–Working light;

–Non marking skirt;

–Non marking wheels;

–Over head guard.

For further information concerning the optional accessories apply to an Authorized Retailer.

USE

WARNING!

On some points of the machine there are some adhesive plates indicating:

–DANGER

–WARNING

–CAUTION

–CONSULTATION

While reading this manual, the Operator must pay particular attention to these symbols.

Do not cover these plates for any reason, in case of damage replace them immediately.

BATTERY CHECK/SETTING ON A NEW MACHINE

The machine requires one 24 V battery, or four 6 V batteries connected according to the diagram (15, Fig. V). The machine can be set in one of the following modes:

a)Battery already installed and ready to be used.

1.Open the hood (13, Fig. C) and hold it by using the related rod (16, Fig. V).

Check that the battery is connected to the machine through the appropriate connector (4, Fig. V).

2.Disengage the lock rod and lower the hood, and ensure that it is correctly closed.

3.Insert the ignition key in the switch (18, Fig. B) in the control panel and turn it to “I” position (without activating the pedal 20, Fig. B). If the green warning light (9, Fig. B) turns on, the battery is ready to be used.

If the yellow or red warning lights (8 or 7, Fig. B) turn on, it is necessary to charge the batteries (see the procedure in the Maintenance chapter).

b)Battery installed on the machine but without electrolyte

1.Open the hood (13, Fig. C) and hold it by using the related rod (16, Fig. V).

2.Remove the battery caps (3, Fig. V).

WARNING!

Be extremely careful when working with sulfuric acid, as it is corrosive. If it comes in contact with the skin or the eyes, wash abundantly with water and call a doctor. Batteries have to be filled up in a properly ventilated area. Wear protective gloves.

6 Terra™ 5200B – 146 1996 000(2)2004-08