Nilfisk-Advance America 5200B Hopper Dumping, Working Light Adjustment, Machine Long Inactivity

INSTRUCTIONS FOR USE

HOPPER DUMPING AFTER USING THE MACHINE

1.The maximum dumping height is 54.3 in (1,380 mm) (see Fig. U).

2.To dump the hopper, drive the machine near the dustbin and proceed as follows:

–Lift the side and main brooms;

–Deactivate the vacuum system by operating the lever (17, Fig. B);

–Press the filter shaker button (14, Fig. B).

WARNING!

Always carry out this operation on a level ground to avoid machine unbalance.

WARNING!

When lifting and dumping the hopper (4, Fig. C), keep the parking brake engaged by pressing the pedal and operating the lever (26 and 19, Fig. B).

3.Keep people far from the machine and especially from the hopper (4, Fig. C).

4.Press both the consent push-button (1, Fig. B) and the hopper lifting push-button (15) to lift the hopper (1, Fig. T) up to the desired position.

5.Press both the consent push-button (1, Fig. B) and the hopper (2, Fig. U) overturning push-button (16, Fig. B) and discharge all the debris in the dustbin (1, Fig. U).

CAUTION!

The hopper (2, Fig. U) can be overturned only after having lifted it at a minimum height of 10.6 in (270 mm).

6.To overturn the hopper back to the horizontal position, press the consent push-button (1, Fig. B) while pressing the hopper overturning push-button (16. Fig. B).

7.To lower the hopper, press both the consent push-button (1, Fig. B) and the hopper lowering push-button (15).

At the end of the work, before leaving the machine:

–Lift the main broom by operating the lever (24, Fig. B).

–Lift the side brooms by operating the levers (21 and 22, Fig. B).

–Deactivate the vacuum system by operating the lever (17, Fig. B), then press the filter shaker push-button (14, Fig. B) for a short interval, and activate the vacuum system again.

–Dump the hopper (4, Fig. C) (see the previous paragraph).

–Remove the key from the ignition switch (18, Fig. B).

–Engage the parking brake by pressing the brake pedal (26, Fig. B) and by operating the brake lock control lever (19).

WORKING LIGHT ADJUSTMENT

If it is necessary to adjust the working light beam aiming (9, Fig. C), operate on the screws (22).

MACHINE LONG INACTIVITY

If you foresee that the machine will not be used for more than 30 days, proceed as follows:

–Check that the machine storage area is dry and clean.

–Disconnect the battery connector (4, Fig. V).

FIRST PERIOD OF USE

After the first period of use (first 8 hours) it is necessary to check that the fixing and connecting elements are correctly tightened, that the visible parts are integral and that there are no tears.

CAUTION!

The hopper can be overturned only if it is not in its original position (horizontal position).

8.The machine is ready to start working again.

146 1996 000(2)2004-08 – Terra™ 5200B 9