SERVICE MANUAL
ENGLISH
HYDRAULIC SYSTEM
REAR WHEEL CONTROL HYDRAULIC CYLINDER DISASSEMBLY/ASSEMBLY
1.Drive the machine on a solid and level ground, then engage the parking brake with the lever (66).
2.Turn the ignition key (76) to OFF position and remove it.
3.Disconnect the hoses (A) from the rear wheel control hydraulic cylinder (B) and plug them immediately.
4.Unscrew the fasteners (C) fi xing the cylinder to the steering tie rods.
5.Remove the screws (D), then remove the cylinder (B).
6.Install the cylinder performing steps from 3 to 5 in the reverse order.
7.Adjust the rear axle
8.Check the hydraulic system oil level (see the procedure in the relevant paragraph).
AA
D
D
CBC
S300912
RS 501
111
