SERVICE MANUAL
ENGLISH
OTHER SYSTEMS
CHECK AND ADJUSTMENT OF SENSOR FOR ENGINE
Check
1.Check that it is not possible to start the machine with the ignition key (76) when the drive pedal (56) is pressed. If necessary, adjust the relevant sensor according to the following procedure.
Adjustment
1.Engage the parking brake with the lever (66).
2.Turn the ignition key (76) to OFF position and remove it.
3.Check that the surface (A) of the sensor (B) is fl ush with the surface (C) of the drive pedal.
If necessary, loosen the sensor mounting nut (D) and adjust the sensor position. When the adjustment is completed, tighten the nut (D).
4.Check that the distance between the sensor surface (A) and the bracket (E) is within 1.5 and 2.5 mm. When checking, move the drive pedal (F) towards the bracket (E) to cancel the drive pedal end play.
If necessary, loosen the nuts (G) and the nut (H), and adjust the position of the bracket (E). When the adjustment is completed, tighten the nuts (G) and (H).
5.Perform step 1 again.
F
A C
D B
G
E
H
G
S301453
RS 501
97
