ENGLISH

SERVICE MANUAL

DUST AND DEBRIS COLLECTION SYSTEM

SUCTION INLET SLIDING PANELS DISASSEMBLY/ASSEMBLY

NOTE

To remove the suction inlet sliding panels, the machine must be lifted with an appropriate hoisting system. Otherwise, remove the suction inlet assembly (D) according to the procedure shown in the relevant paragraph. See the following disassembling procedures.

1.Place the machine on the appropriate hoisting system (if present) and lift it.

If the hoisting system is not available, remove the suction inlet assembly (D) (see the procedure in the relevant paragraph).

2.Remove the mounting screws (A), and (B), then remove the sliding panels (C), (D), and (E).

3.Install the new sliding panels (C), (D), and (E) and fasten them with the screws (A), and (B).

4.Also check that, when the wheels (F) contact the ground, the sliding panels (C), (D), and (E) do not touch the ground, otherwise the wheels (F) must be replaced to avoid an excessive wear of the sliding panels (for wheel replacement procedure, see the relevant paragraph).

5.Perform step 1 again.

6.If necessary, perform the suction inlet and skirt height and operation check (see the procedure in the relevant paragraph).

F E D B F

A

C

C

A

F

S301486

32

33015500(3)2008-02

RS 501

Page 34
Image 34
Nilfisk-Advance America RS 501 service manual Suction Inlet Sliding Panels DISASSEMBLY/ASSEMBLY