Nortel Networks NS4540 manual Verify updated contents, Save the changes to flash

4) Verify updated contents

After uploading the custom pages, open browser to verify the correctness of contents. If not correct, modify the pages and return to previous step to upload again.

5) Save the changes to flash

Telnet to the NETCOMM NS4540. And run command "Up -w" to write the complete web pages into flash. The detailed procedures are list as below,

1.Open DOS window

2.Enter "telnet <IP Address of NETCOMM NS4540 >"

3.Enter "root" and "pass" as username and password

4.Enter "Up -w" to start the web content update program. The command is case sensitive. Don't enter the wrong case or you'll get the command not find error message. After processing about 30 seconds, the NETCOMM NS4540 will restart automatically and complete the web content update. Now you can open the browser to see the new web content.

Note:	The limitation of overall size of content pages is around 700K Bytes. Any file
	added/updated plus original downloaded file (~550K Bytes) should not exceed
	this size; otherwise, some files will be truncated or corrupted. If the corruption
	of any page happens, you will have to reload the original binary (see Appendix
	A - Upgrading the Software) in order to recover the corruption.

For example, the NETCOMM NS4540 IP address is 192.168.0.200, then C:\temp>telnet 192.168.0.200 C:\temp> Telnet session

Open Telnet session Login: root Password:

Enter "pass" as default Welcome to VidSvr on Telnet ... IVS> Up -w Upgrade WWW Pages...

Frozen here, close and open browser After 30 seconds to verify the changes.

NetComm NS4540 Dome Camera User Guide	YML7** Rev1
52	www.netcomm.com.au