10 Installing the DFC on systems equipped with DVCs
3. | Switch SW1 should be set according to the following table: | |||||||||
|
|
|
|
|
|
|
|
|
| |
Position | 8 | 7 | 6 | 5 | 4 | 3 | 2 | 1 |
| |
|
|
|
|
|
|
|
|
|
| |
State | off | on | off | off | on | on | on | on |
| |
|
|
|
|
|
|
|
|
|
|
|
4. | Switch SW2 should be set according to the following table: | |||||||||
|
|
|
|
|
|
|
|
|
| |
Position | 2 | 1 |
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
| |
State | on | on |
|
|
|
|
|
|
| |
|
|
|
|
| ||||||
5. | Ensure there is a jumper on position 10 of the INTERRUPT. | |||||||||
| Note: The settings in these table are the default values and should be set | |||||||||
|
| properly when the board is received. Refer to Figure 2 on page 5 for | ||||||||
|
| the location of the switch SW1, SW2 and the INTERRUPT jumpers. | ||||||||
6. | Carefully hold the DFC along the top only. Insert the card by aligning | |||||||||
| between the metal groove on one side and the slot opening on the other side. | |||||||||
7. | Push the DFC straight in until it is snugly in place. Ensure the edge connector | |||||||||
| is firmly inserted into the socket. |
|
|
|
|
| ||||
8. | Fasten the slot cover screw in the DFC slot cover. |
|
| |||||||
| Note: If there is a DVC in slot 6 of the NAM, you must connect the PEB | |||||||||
|
| cable to the DFC before installation. If there is a DVC in slot 7 of the | ||||||||
|
| NAM II, you must connect the PEB cable to the DFC before | ||||||||
|
| installation. |
|
|
|
|
|
|
| |
FAX Installation Guide | P0886634 Issue 1.0 |
