Fig. 120 - BATTERY

INSTALLATION

•Closely examine the threads of the Battery Hatch and Housing for any signs of damage that might prevent proper threading.

•Closely examine the inside of the Battery Compartment for any signs of corrosion indicating entrance of moisture into the unit.

•If corrosion is found, return the GEO to an Authorized

Oceanic Dealer, and DO NOT attempt to use it until it has received factory service.

•If moisture is found, it is best to have the unit inspected and cleaned by an Authorized Oceanic Dealer.

•If it is necessary to clean the Battery Compartment, flush it and all components with a solution of 50% white vinegar and 50% fresh water. Rinse with fresh water, and allow to dry overnight or blow dry with a hair dryer set at no heat.

Battery Installation

•Slide a new 3 volt type CR2430 Lithium Battery, negative side down into the Battery Cavity. Slide it in from the Left side (Fig. 120) and ensure that it slides under the contact clip on the lower/right rim of the cavity.

•Lightly lubricate the new Hatch O-ring with silicone grease and place it on the inner rim of the Battery Hatch. Ensure that it is evenly seated (Fig. 121).

Fig. 121 - BATTERY

HATCH O-RING

126