Olicom A400A manual Routing over RFC 1483 bridge

Routing over RFC 1483 bridge

Bridged protocol data unit is encapsulated using RFC 1483 protocol over an ATM network and this operation mode use ATM/ADSL to simulate as a Ethernet network router to route information between LANs.

1.VPI: Enter the number of the virtual path identifier in the VPI field.

The VPI is a number in the range 0-255. Consult your ATM transport administrator for what number you should enter in this field.

2.VCI: Enter the number of the virtual circuit identifier in the VCI field.

The VCI is a number in the range 0-65534. Consult your ATM transport administrator for what number you should enter in this field.

3.Encapsulate: Select the encapsulation setting.

You choose LLC or VC Mux to configure whether the virtual circuit uses LLC-SNAP encapsulation or Vc-based multiplexing.

4.IP: Enter the IP address the ADSL router will use on this virtual circuit in the IP Address field.

The IP address you enter must not be in use by other devices on this virtual circuit. The domain of Ip have to not same as LAN.

17