General Operation
This section describes the use of direct operation with the main unit or remote control buttons. For information about operation using the menu, see “Menu Operation Method” on Page
Input Selection
This operation selects the input signal to be projected.
Main unit operation: Press the SOURCE button.
(It will not function while the menu or the quick menu is displayed.)
When Auto Source is On
If there is no input signal at the source that was previously used, the projector automatically selects the next source that has an input signal.
When Auto Source is Off
Each press of the button switches the selection one step in the sequence of Analog RGB → YPbPr → Digital RGB → VIDEO →
Remote control operation: Press the desired input selection button.
When Auto Source is On
When an input signal is not present at the selected source, the projector automatically selects the next source that has an input signal.
When Auto Source is Off
The projector switches to the selected source regardless of whether an input signal is present.
MENU
SOURCEAUTO
QUICK
MENU
ON POWER OFF
FREEZE MUTE PIP
DIGITAL RGB YPbPr
VIDEO
QUICK ASPECT AUTO
Note
*When you do not operate source selection, the projector will assume the input selection condition that was previously used.
*See “Auto Source” on Page
*YPbPr input selection cannot be used when YPbPr is set to “Disable”. See “YPbPr” on Page