16
4.Setting and Storing Personal Data
4. Setting and Storing Personal Data

For the measurement of body fat percentage and visceral fat level, it is necessary to set

your personal data (age, gender, height).

This section describes setting the personal profile setting for number 1 as an example.

1. Push the power switch to turn on the unit.
“CAL” blinks on the display, then the display changes to
0.0 kg.
Wait until 0.0 kg appears on the display.
2. Take out the display unit.
Note: You can change the measurement units used for the height and weight settings. All height
and weight measurements are displayed using the new measurement units. The change
remains in effect until you change the measurement unit s etting again.To change the
measurement unit:
1) Keep the button pressed until “lb” and “kg” blink on the d isplay.
2) Press the or button to select the desired measurement unit, “lb” or “kg”. This will
automatically change “cm” and “in”.
3) Press the SET button to confirm the change.
Buttons Used in this Procedure
Down ( ) button
Press this button to go back one.
Press continuously to rapidly
decrease.
Up ( ) button
Press this button to advance one.
Press continuously to rapidly
advance.
SET button
Use this button to confirm the
personal data and move to the
next item after confirming the set
item.
Personal profile number
button Personal profile number
button
HBF500-E.book Page 16 Friday, October 24, 2008 10:41 AM