Connecting Your Speakers—Continued
Configuring the Speaker Impedance
In this model, the factory default for speaker impedance is “8 ohms.” When you change the speaker impedance setting, read “Speaker Connection Precautions” on page 13 carefully before performing the procedures below.
Note: | 3 | Use the Up and Down [▲]/[▼] | |
Be sure to minimize the volume level on the receiver | |||
buttons to select “1. Hardware | |||
before configuring the speaker impedance. |
| ||
| set,” and then press [ENTER]. | ||
|
|
RECEIVER | The Hardware Setup menu appears on | |
the display. | ||
|
ENTER
SET UP 
1 | Turn on the power. |
|
2 | Press the [RECEIVER] button | |
and then the SETUP button on | ||
| ||
| the remote controller. |
4
5
6
Use the Up and Down [▲]/[▼] buttons to select “Impedance: 8 ohms” indication.
Change the impedance value to “6 ohms” using the Left and Right [
]/[
] buttons.
Press the SETUP button on the remote controller to complete the setting.
When you restore the impedance setting to 8 ohms, use the same procedures above.
15
