Onkyo TX-L55 Connecting Antenna, Ohm coaxial cable, Insert the central conductor 1, as

TX-L55_En.book Page 19 Tuesday, June 1, 2004 9:02 AM

Connecting Antenna—Continued

■ Using the 75/300-ohm Antenna Adapter ■ Using a TV/FM Antenna Splitter

The 75/300-ohm Antenna Adapter is not supplied with American and European models.

The 75/300-ohm antenna adapter can be used to connect an FM antenna using either 75-ohm coaxial cable or 300-ohm twin-core flat cable.

■Connecting 300-ohm Flat Cable

1	Using a screwdriver, loosen the
	two screws on the adapter, wrap
	the bare wires around the
	screws, and then retighten them,
	as shown.
2	Plug the adapter into the 75 Ω socket.

■Connecting 75-ohm Coaxial Cable

1	Strip and prepare the
		15 mm
	75 ohm coaxial cable,	mm mm mm
		6	3		6
	as shown.
		1/4"		1/8"	1/4"
			5/8"
2	Using your fingernails or a small screw-
	driver, lever the adapter’s tabs outward

and remove the cover, as shown.

3	Move the small wire inside the adapter
	from position A to position B, as shown.
	Position A
	Wire
	Position B
4	Insert the central conductor (1), as
	shown, and use a small pair of pliers to

clamp the shielding and outer insulation sections of the cable (2), as shown.

1

2

Make sure the shielding is not touching the central conductor.

5 Refit the adapter’s cover, and then plug the adapter into the 75 Ω socket.

It’s best not to use the same antenna for both FM and TV reception, as this can cause interference problems. If cir- cumstances demand it, use a TV/FM antenna splitter, as shown.

TV/FM antenna splitter

To TX-L55 To TV (or VCR)

19