Onkyo TX-L55 instruction manual Controlling Other Components, Codes for Onkyo DVD Players, page

TX-L55_En.book Page 55 Tuesday, June 1, 2004 9:02 AM

Controlling Other Components

You can use the TX-L55’s remote controller (RC-575S) to control your DVD player and TV, even if it’s made by another manufacturer. To do this, you first need to enter the appropriate remote control code for your DVD player and TV. Then you need to select the corresponding remote controller mode (see page 11).

						Transmit
ON	STANDBY					indicator
				TV
STANDBY			I		INPUT
					+
1		2	3
					TV CH
4		5	6		-
Number
7		8	9
buttons					TV VOL
+10		0	CLEAR
--/---					REMOTE
TONE
	_				MODE
			+		AMP
					TUNER	DVD
DVD	V1		V2		DVD
INPUT SELECTOR						TV
TV	AUX		TUN		TV
DIMMER					SLEEP
TV		U	MEN
	PMEN			U
INPUT	TO
+
CH		ENTER			VOL
DISC
-	EXIT		GUIDE
PREV	R		TUP
	ET	URN
CH			SE
DISPLAY					MUTING
PLAY MODE	SP A		SP B		RANDOM
AUDIO	SUBTITLE		ANGLE		LAST M
DIRECT	STEREO		SURR		DSP

Entering Remote Control Codes

Entering the appropriate remote control code for your DVD player and TV will allow you to control them with the TX-L55’s remote controller. You’ll need to perform this procedure twice to enter the codes for both your DVD player and TV.

1	Look up the remote control code
	for your DVD player or TV.
	See “Remote Control Codes” on
	page 56.
2	While holding down the REMOTE
REMOTE	MODE [DVD] or [TV] button,
MODE	press the [STANDBY] button.
AMP
TUNER

3			Within 30 seconds, use the
			number buttons to enter the 4-
1	2	3	digit remote control code.
4	5	6
7	8	9
+10	0

4	Select the remote controller
	mode, point the remote con-
	troller at your DVD player or TV,
	and check its operation.
	Remote controller buttons that can be
	used with DVD mode are shown on
	page 12. Those that can be used with
	TV mode are shown on page 14.

If the remote controller doesn’t work as expected, try entering the code again, or try another code.

Codes for Onkyo DVD Players

The remote control code you use for an Onkyo DVD

player depends on whether it’s connected via		, as fol-
lows:
5001: Use this code if you’ve connected an			cable
and an analog audio cable (RCA) to your DVD
player. This is the default setting, so if you’re
using	, you don’t need to change anything.

Point the remote controller at the TX-L55 to control the DVD player.

5002: Use this code if your DVD player doesn’t have

an socket, or you’re not using . Point

the remote controller at the DVD player to con- trol it.

DVD

TV

STANDBY

55