Basic Setup—Continued
3
CH SEL
Use the [CH SEL] button to select the speakers, and use the [LEVEL+] and
If you want to use the TV input source with only the analog TV IN, change the TV input source assignment from OPT1 to
You can change the assignments as follows.
LEVEL LEVEL
- +
The level can be adjusted from
If you don’t press anything for two sec- onds, the next speaker will be selected automatically.
1
AMP
TUNER
DVD V1 V2
INPUT SELECTOR
Press the REMOTE MODE [AMP] button followed by the [INPUT SELECTOR] button for the input source whose assignment you want to change.
There is no assignment for the TUNER input source.
4 | Repeat step 3 until the volume of |
| |
| the test tone coming from each |
| speaker is the same. |
| Speakers that you set to No or Non in |
| the Speaker Configuration (page 48) do |
| not output the test tone. |
|
|
5 | Press the [TEST TONE] button. |
| |
TEST TONE | The setup menu closes. |
| Don’t forget to turn down the volume if |
| you turned it up while setting the levels. |
TV AUX TUN
2 | Press the [SETUP] button. |
|
3 | Use the Up and Down [ ]/[ ] |
| buttons to select “Input Set,” and |
Notes:
•This procedure can also be performed by using the [SETUP] button. Press the REMOTE MODE [AMP]
button followed by the [SETUP] button. Use the Up and Down []/[ ] buttons to select “Level Cal,” and then press [ENTER]. Use the Left and Right [ ]/[ ] buttons to adjust the speaker volume, and use the Down [ ] button to select the next speaker. Unlike the
ENTER
ENTER
then press [ENTER].
above procedure, the next speaker will not be selected automatically after two seconds.
Assigning Inputs to Input Sources
Digital Audio Input Setup
To enjoy Dolby Digital and DTS, you must connect your DVD player to the
This section explains how to change the digital audio input socket to input source assignments. You only need to change them if your connections don’t match the defaults listed in the following table.
Input source | Default digital input assignment |
DVD | COAX |
|
|
TV | OPT1 |
|
|
VIDEO1 | OPT2 |
|
|
VIDEO2 | - - - - (Analog) |
|
|
AUX | - - - - (Analog) |
|
|
4 | Use the Up and Down [ ]/[ | ] |
| buttons to select “Digital In,” and | |
| then use the Left and Right [ | ]/ |
ENTER | [ ] buttons to select: |
|
COAX: Select if the component is connected to the COAX DIG-
ITAL INPUT.
OPT1: Select if the component is connected to the OPT1 DIGI-
TAL INPUT.
OPT2: Select if the component is connected to the OPT2 DIGI-
TAL INPUT.
5 | Press the [SETUP] button. |
| |
| The setup menu closes. |
For example, if you connect your DVD player to the
OPT 1 DIGITAL INPUT, you’ll need to change the
DVD input source from COAX to OPT 1.
31