Onkyo TX-NR1000 Index Parts and Facilities-Continued, 2STANDBY indicator 9, 3STANDBY/ON button

Index Parts and Facilities—Continued

For further operational instructions, see the pages indicated in brackets [ ].

1POWER switch (for all models other than USA, Canadian, and Australian models) [50]

Press to turn on and off the main power supply for the TX-NR1000/TX-NR5000E. When the TX-NR1000/TX-NR5000E is turned on with the [POWER] switch, the [STANDBY] indicator lights.

•Before turning on the power, check to make sure that all cords are properly connected.

•When the power is turned on, a sudden surge of current will occur that may adversely affect the operation of other devices. To prevent this, do not plug the TX-NR1000/TX-NR5000E into the same circuit used by sensitive equipment, e.g., computers.

2STANDBY indicator [9, 50]

Lights when the TX-NR1000/TX-NR5000E is in the standby state and when a signal is received from the remote controller.

3STANDBY/ON button [50]

If pressed with the [POWER] switch turned on (with the receiver plugged in for USA, Canadian, and Australian models), the TX-NR1000/TX-NR5000E turns on and the display lights up. If pressed again, the TX-NR1000/TX-NR5000E returns to the standby state. In the standby state, the display is turned off and the TX-NR1000/TX-NR5000E cannot be operated.

4Remote control sensor [9]

5DISPLAY button [54]

Press to display information about the current input source signal. Each time you press the [DISPLAY] button, the screen changes to show you different information concerning the input signal.

6Front display

7Input source buttons and indicators (DVD, VIDEO 1–7, TAPE 1-2, TUNER, PHONO, CD, and NET AUDIO) [50, 60, 63, 76]

Press these buttons to select the input source for the main zone.

After selecting the input source, the corresponding indicator turns blue. If you select Zone 2, the indicator turns green. If you select Zone 3 or Rec, the indicator turns red.

8MASTER VOLUME dial [50]

Use to control the volume in the main zone. The volume for the remote zone (Zone 2 and Zone 3) is independent.

9OPEN button

Press this button to open the front panel door.

0PURE AUDIO indicator [59]

Lights during pure audio playback.

11