Onkyo TX-NR1000 Prepare the component for audio/video, Recording recorder side, Main B mode

Recording a Source—Continued

3 Press the [REC/ZONE3] button, and within

3seconds, select “Rec Sel:SOURCE” with the [CONTROL/TUNING] dial.

Pressing the [REC/ZONE 3] button makes the [STANDBY] indicator blink for 3 seconds. Select the target sources while the indicator is blinking. The name of the source to be recorded is indicated in the display window. Audio/video recording is enabled on the component for which “Rec Out” was specified in step 2.

4	Prepare the component for audio/video
	recording (recorder side).
5	Start audio/video recording.
	You cannot listen to a broadcast from one station

while recording a broadcast from another station.

Recording the Video from One Source and the Audio from Another Source

You can add audio signals from a source to a video of another source to make your own custom video record- ings. Below is an example of recording audio signals from a CD player connected to the DIGITAL IN OPTI- CAL 2 jack and the video from a video camera con- nected to VIDEO IN 3 onto a video cassette tape on a VCR connected to VIDEO OUT 2.

Operate this function in the main room.

1	Turn on the power supply to the
	TX-NR1000/TX-NR5000E in MAIN A or
	MAIN B mode.
2	Check connections and settings to the
	recording component.
	Refer to steps 2 and 3 in “Recording Audio/Video
	While Playing” on page 70.
3	Press the [CD] input source button.
4	Press the [SETUP] button to display Main
	menu, and turn the [SELECT/PRESET]
	dial to select “Input Setup.”
	After selecting “Input Setup,” press the [ENTER]
	button.
	To carry out steps 3-6 on the remote controller, fol-
	low the procedures described on page 95.
5	Turn the [SELECT/PRESET] dial to select
	“Video Setup,” and press the [ENTER]

button.

6	Turn the [SELECT/PRESET] dial to select
	“Composite Video,” and set it to “3” with
	the [CONTROL/TUNING] dial.
	After setting to “3,” press the [SETUP] button.
7	Insert a CD in the CD player and insert a
	tape in the video camera connected to the
	VIDEO IN 3 jacks.
8	Insert a tape in the VCR connected to the
	VIDEO OUT 2 jacks.
9	Press the [REC/ZONE 3] button, and

within 8 seconds, select “Rec Sel:SOURCE” with the [CONTROL/TUN- ING] dial.

Now, the CD player has been selected as the audio input source, and VIDEO 3 as the video input source.

10 Start recording on the VCR, and start play- ing on the CD player and the video cam- era.

Playback starts on the component selected in steps 3-6.

Note:

Switching the source during audio/video record- ing will record the source newly selected.

71