Onkyo TX-NR1000 Resetting the Remote Controller, The remote controller enters Custom, mode

Other Settings for the Remote Controller—Continued

Resetting the Remote Controller

You can reset the remote controller to its default set- tings.

1	Press and hold the [CUSTOM] but-
CUSTOM	ton for more than three seconds.
	The remote controller enters Custom
	mode.
2	Roll the scroll wheel to select
	“SETUP,” and then press the scroll
	wheel.

3	Roll the scroll wheel to select
	“RESET,” and then press the scroll
	wheel.

4	Roll the scroll wheel to select
	“YES,” and then press the scroll
	wheel.
	The remote controller is reset to its
	default settings.

Using the Remote Controller with Radio Frequency (RC-558M only)

You can set the remote controller’s transmission signal format to either infrared (IR) or radio frequency (RF). The default setting is IR.

This is useful when, for example, the TX-NR1000/ TX-NR5000E is installed in a rack or is not in line of sight of the remote controller as it allows you to use a commercially available RF receiver to pick up com- mands from the remote controller, which are then fed to the TX-NR1000/TX-NR5000E via its IR IN socket. For this to work, you must assign the same ID and channel to the remote controller and RF receiver.

1	Press and hold the [CUSTOM] but-
CUSTOM	ton for more than three seconds.
	The remote controller enters Custom
	mode.
2	Roll the scroll wheel to select
	“SETUP,” and then press the scroll
	wheel.

3	Roll the scroll wheel to select “IR/
	RF,” and then press the scroll
	wheel.

4	Roll the scroll wheel to select “IR”
	or “RF,” and then press the scroll
	wheel.
	When you select “IR.”

5	If you select “RF,” roll the scroll
	wheel to select the same ID as the
	RF receiver, and then press the
	scroll wheel.
	IDs 0 to 9 and A to F can be selected.

6	Roll the scroll wheel to select the
	same channel as the RF receiver,
	and then press the scroll wheel.

Channels 0 to 3 can be selected.

If the ID and channel have been set suc- cessfully, “OK” appears on the display.

141