Onkyo TX-NR1000 Dolby Headphone Setup Sub-menu, Listening Mode Setup—Continued, e. Subwoofer

Listening Mode Setup—Continued

A+B: Outputs the source from the speakers connected to the SURR L/R SPEAKERS A and SURR L/R SPEAKERS B terminals.

e. Subwoofer

This option configures the subwoofer to use when playing the source. Select the terminal to which the subwoofer you want to use is connected. This setting can be made when the “(Speaker A) Subwoofer” is set to an option other than “Not Used” in the Speaker Configuration sub-menu. However, when the “(Speaker

B)Subwoofer” is set to an option other than “Main A” in the Speaker Configuration sub-menu, the available options will be “A” or “Not Used.”

A (Default): Outputs the source only from the subwoofer connected to the SUBWOOFER PRE OUT A terminal.

B: Outputs the source only from the subwoofer connected to the SUBWOOFER PRE OUT B terminal. A+B: Outputs the source from the subwoofers connected to the SUBWOOFER PRE OUT A and SUBWOOFER PRE OUT B terminals.

Not Used: No subwoofers are used for playback.

In Zone 2, you can set the following options.

a. Mode

This option allows you to configure the width of a virtual sound image which is simulated using two speakers while you use the Dolby Virtual Speaker effect.

Wide: The breadth of the sound image is emphasized.

Reference (Default): The general 5.1 ch suround sound is simulated.

b. Decode (2 ch)

This option allows you to select the decode mode before the Dolby Virtual Speaker effect is applied.

Dolby Pro Logic II: The Dolby Virtual Speaker effect is applied after the signal is decoded with Dolby Pro Logic II.

DTS NEO:6: The Dolby Virtual Speaker effect is applied after the signal is decoded with DTS NEO:6.

Dolby Headphone Setup Sub-menu

This sub-menu allows you to enable/disable the Dolby

Headphone function when you use the headphones.

a. Mode

On (Defalt): Enables the Dolby Headphone function.

Off: Disables the Dolby Headphon function.

117