Onkyo TX-NR1000 instruction manual Connecting and Setup, When Connecting Only Speakers Zone

Enjoying Movies and Music in the Remote Zone (Zone 2/3)

You can connect speakers and amplifiers for the remote zone, and enjoy different sources in a remote zone (Zone 2 or Zone 3).

There are three ways to enjoy in a remote zone:

Connecting and Setup

When Connecting Only Speakers (Zone 2)

•You can enjoy a different source in a remote zone while a 5.1 channel source is being played in the main room.

•Adjust the volume level on the TX-NR1000/ TX-NR5000E.

Main Room

TV

TX-NR1000/

TX-NR5000E

SURR BACK R (ASSIGNABLE)SURR BACK L (ASSIGNABLE)

SPEAKERS B SPEAKERS B

	Zone 2
1	Connect the speakers for Zone 2 to SURR
	BACK L/R SPEAKERS B terminals.
2	Connect the video component for Zone 2
	to any of the composite VIDEO OUT 1-4
	terminals.
3	Set the Setup menu.

1.On the Setup menu (See page 88), select “Speaker/Output Setup” →“Speaker Con- figuration,” and set “Speaker B Surr Bk” to “Powered Zone 2.”

2.Similarly, select “Speaker/Output Setup” → “Video Output Assign,” and set the terminal connected to the component to “Zone 2 Out.”

3.Press the [SETUP] button to close the menu.

66

When Connecting the Pre-main Amplifier or Receiver (Zone 2 or Zone 3)

•You can enjoy a different source in a remote zone while a 7.1 channel source is being played in the main room.

•Adjust the volume level on the pre-main amplifier or receiver in the remote zone.

Main Room
		TV
	TX-NR1000/TX-NR5000E
R	L	OUT	OUT
			VIDEO
Zone 2/Zone 3

	TV
	IN
	R L
	Receiver/
	Pre-main amplifier
1	Connect the pre-main amplifier or
	receiver for Zone 2 or Zone 3 to the

TX-NR1000/TX-NR5000E.

Connect to any of the following terminals:

•AUDIO OUT 1-5 Default:

Analog 4 (AUDIO OUT 4): Zone 2 Out

Analog 5 (AUDIO OUT 5): Zone 3 Out

•DIGITAL OUT OPTICAL 1-2

•DIGITAL OUT COAXIAL 1-2

2	Connect the speakers for Zone 2 or Zone
	3 to the pre-main amplifier or receiver.
3	Connect the video component for Zone 2
	or Zone 3 to any of the composite VIDEO
	OUT 1-4 terminals.
4	Set the Setup menu.

1.On the Setup menu (See page 91), select “Speaker/Output Setup” → “Audio Output Assign,” and set the terminal to which the component is connected to “Zone 2 Out” or “Zone 3 Out.”

2.Then, set “Zone 2 Out” or “Zone 3 Out” in the Audio Output Assign sub-menu to “Line Out (fixed).”

3.Similarly, select “Speaker/Output Setup” → “Video Output Assign,” and set the terminal to which the component is connected to “Zone 2 Out” or “Zone 3 Out.”

4.Press the [SETUP] button to close the menu.